Place
an Order
Back to Product Information
& Support |
|
|
|
MB8000 Reset to Factory Default Procedure
Use this procedure
to reset the network configuration values, including the MB8000
IP
Address, Subnet Mask, and so on. The current MB8000 Software
will not be deleted. This
procedure may be required if the password is forgotten or the
configurations are forgotten.
When MB8000 is working in normal status, press and holds the
RELOAD button for more
than 30 seconds, until all the indicator lights turn off. Then
release RELOAD button, press
the RESET button to set up the device again. The factory default
network values are
restored. Please refer Default Settings the factory default value.
Users can also reload an MB8000 through WEB GUI.
Warning:
If you press and hold the RELOAD button for more than 15 seconds
immediately after the MB8000 is power on or reset, the MB8000
will enter into
Force Reload Procedure. The software in the MB8000 will be
erased. You will
have to download software into MB8000 to make it work again |
|
